Sun, Mar 22, 9:39 PM CDT

Renderosity Forums / Carrara

All Forums

Welcome to the Carrara Forum

Forum Coordinators: Kalypso, Anim8dtoon

Carrara F.A.Q (Last Updated: 2026 Feb 15 8:54 pm)

 

Visit the Carrara Gallery here.

Carrara Free Stuff here.

 
Visit the Renderosity MarketPlace - Your source for digital art content!
 

 

Subject: Vertex room problems in C5Pro

ominousplay opened this issue on Dec 04, 2005 · 4 posts
Back to Forum Print
ominousplay ( ) posted Sun, 04 December 2005 at 11:22 PM · edited Thu, 19 March 2026 at 3:56 AM

I ran into some strange duplications in the vertex room. Using a mac. It happened when I drew with the line tool, then connected points... instead of connecting and making a mesh, it duplicated points and lines. after a while I came put with two empty meshes. I never had this happen in C4Pro. Any ideas? R

Never Give Up!

ominousplay ( ) posted Sun, 04 December 2005 at 11:47 PM

I just tried the same on PC and found it was the same. I tried joining between points, and it duplicated the lines and point. Not so in C4Pro. What is going on?

Never Give Up!

Letterworks ( ) posted Mon, 05 December 2005 at 3:18 AM

Have you reported tis to Eovia? It may not be too late for them to check it before C5 "goes live"! mike

Nicholas86 ( ) posted Mon, 05 December 2005 at 5:31 AM

Attached Link: http://www.eovia.com/support/bug_report.asp

Report it! :)

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.