ominousplay opened this issue on Dec 04, 2005 ยท 4 posts
ominousplay posted Sun, 04 December 2005 at 11:22 PM
I ran into some strange duplications in the vertex room. Using a mac. It happened when I drew with the line tool, then connected points... instead of connecting and making a mesh, it duplicated points and lines. after a while I came put with two empty meshes. I never had this happen in C4Pro. Any ideas? R
Never Give Up!
ominousplay posted Sun, 04 December 2005 at 11:47 PM
I just tried the same on PC and found it was the same. I tried joining between points, and it duplicated the lines and point. Not so in C4Pro. What is going on?
Never Give Up!
Letterworks posted Mon, 05 December 2005 at 3:18 AM
Have you reported tis to Eovia? It may not be too late for them to check it before C5 "goes live"! mike
Nicholas86 posted Mon, 05 December 2005 at 5:31 AM
Attached Link: http://www.eovia.com/support/bug_report.asp
Report it! :)