Wed, May 29, 2:23 AM CDT

Welcome to the Poser 11 / Poser Pro 11 OFFICIAL Technical Forum

Forum Moderators: nerd

Poser 11 / Poser Pro 11 OFFICIAL Technical F.A.Q (Last Updated: 2024 May 25 1:59 pm)

banner

Welcome to the Poser Forums! Need help with these versions, advice on upgrading? Etc...you've arrived at the right place!


Looking for Poser Tutorials? Find those HERE

Subject: Export / Import obj and Morph

lsauvage opened this issue on Nov 23, 2019 · 3 posts
Back to Forum Print
lsauvage ( ) posted Sat, 23 November 2019 at 6:25 AM · edited Sat, 16 March 2024 at 11:28 PM

Hi, i'm trying to morph LaFemme with 3DCoat. But i never succeed cause "wrong number of vertice" at the import. I thought it was 3D coat that changed geometry and to be sure before complaining in 3DCoat forum i did an experiment, and now i suspect Poser :

I export LaFemme with export > obj. and i unckeck weld body part seams and i checked As Morph targer too. Than i import this export right into a morph => "wrong number of vertice"

What is the key ? What did i do wrong ?

Thank you.

Ludovic

caisson ( ) posted Sat, 23 November 2019 at 9:03 AM

Use the original obj file from the Geometries folder for La Femme (or any other figure) instead of an exported obj from Poser. Make sure you back up the file and don't overwrite the original.

----------------------------------------

Not approved by Scarfolk Council. For more information please reread. Or visit my local shop.

lsauvage ( ) posted Sat, 23 November 2019 at 4:01 PM

Thank you very much, It works very well.

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.