Filter: Safe
Filter: Safe | Thu, Jul 30, 11:28 AM CDT

Renderosity Forums / Carrara

All Forums

Welcome to the Carrara Forum

Forum Coordinators: Kalypso, Anim8dtoon

Carrara F.A.Q (Last Updated: 2026 Jul 30 3:53 am)

 

Visit the Carrara Gallery here.

Carrara Free Stuff here.

 
Visit the Renderosity MarketPlace - Your source for digital art content!
 

 

Subject: Symetrical Modeling problem

alias59 opened this issue on Oct 03, 2006 · 2 posts
Back to Forum Print
alias59 ( ) posted Tue, 03 October 2006 at 11:22 AM · edited Wed, 22 July 2026 at 9:50 AM

Is there a way to lock the movemtent of vertices to a plane?

While doing symetrical modeling I would like all vertces  (of the object's certer/plane) to NOT move in the X axis.  This would keep the center/plane perfectly aligned and make welding a lot easier.  I always have a few vertices that get move off the center plane whic leads to problems.

thanks for any advice.

MarkBremmer ( ) posted Tue, 03 October 2006 at 9:53 PM

Attached Link: Aligning Vetexes

I'm not aware of a way to lock the vertices. However, you can easily align them to a drawing plane. Check out the link above to see how.





Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.