Axle Stand.

3D Modeling Transportation posted on Oct 24, 2019
Open full image in new tab Zoom on image

Hover over top left image to zoom.
Click anywhere to exit.

Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.


An Axle Stand I created. No textures but separate material zones for each part. In obj format and only tested in Daz Studio but it should work fine in Poser. Made as two separate parts so load the base then the prop. Both can be scaled to your needs. Prop can be moved up and down using the Y Translate. Enjoy! Mike.

Comments (4)

TheFiercebadRabbit 1:23PM | Thu, 24 October 2019

Big thanks Nice model work


Maxidyne 4:45PM | Thu, 24 October 2019

You're welcome.


3DClassics123456 4:40AM | Fri, 25 October 2019

Original and rare! You ought to sell it at a cheap price. Very useful for garage scenes.


Maxidyne 12:22PM | Fri, 25 October 2019

Thank's my friend. I have thought about this and will make more Garage bits.

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.