Falcon Model by Kixum ()
Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.
This is about 35 hours worth of work. I will make some changes to it but in general, I'm done with the modeling.
Texturing is next (and that's something I'm no good at).
The entire model was created in Carrara 6 Pro. Texturing (bump map only) was done in Paint shop Pro. The dual coloring on the Pilots tunnel used the same map as was applied to the bump for that component.
Total components = 1240. All pieces except for 2 were created from scratch for this project. I had done the cockpit for an older version of the Falcon which I tossed when I started this version. So, ultimately, I did the whole model from scratch but two of the pieces are older than the rest.