Colt 1911A1 by VladiT
Close
Hover over top left image to zoom.
Click anywhere to exit.
Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.
Description
This 3D-model of the gun is made by AUTODESK INVENTOR and the subsequent visualisation by 3D-STUDIO-MAX
Comments (8)
Thelby
This is one Bad Pistol here!!! Nice work!!!
PSDuck
Good wear on the pistol. I'd loke to give some tips for a bit more character. The grips should have wear in the right places, where the fingers grip it. The wood should lose its newness to the crosshatching, where the hand and fingers contact it. Depending on the wood's stain, it may have worn partially of fully off. The serrated rear of the slide would have a bit or a lot of shinyness due to the finish being worn off from usage. These are just a few points, not criticisms. As is, the pistol has character. Good work.
VladiT
Many thanks for your remarks. I will necessarily consider them in the future. Vladimir.
katy555
Simply Breathtaking, fabulous design...
pangman
you again! damn, your a madman, I am so impressed, so you say this is by the inventor of 3DS, did you model this or that guy?
VladiT
I apologise, I badly know English and have probably misunderstood your remark. Yes, this model is originally made in the Autodeck of Inventor-11, and then is made render in 3D-Studio-MaŃ…. By the way, very much I recommend Inventor for weapon modelling. There all is much easier and more convenient, than in 3-D Studio. Once again I ask to excuse me if I have misunderstood you.
DarkStormCrow
Outstanding! 1911 accept no substitutes :O)
boeing
I have one of those...nice job!!