Round Toe Pumps for Project Evolution by RobZhena ()
3D Figure Essentials 144 downloads
Software: Poser 10 / Poser Pro 2014 +, Poser Pro 11
License: This is licensed for commercial or non-commercial use.
Product Notes
Important: I recommend that you increase the maximum bend of the left and right feet of PE to wear these heels. See Read Me. The height of the heel is about 4 inches.
I rigged these using a mesh created by David Mussaffi found at Pinshape (https://pinshape.com/users/35096-david-mussaffi#designs-tab-open), which is licensed under Creative Commons “CC - Attribution - Share Alike” (https://creativecommons.org/licenses/by-sa/4.0/legalcode), which permits:
Share-copy and redistribute the material in any medium or format
Adapt-remix, transform, and build upon the material
for any purpose, even commercially.
The original mesh is an stl file of the shoe body only that I converted to obj, added a heel and new material zones, and rescaled. This freebie is, per the original license, accorded the same licensing status.
The materials are from Merchant Resource-Seamless Leather by Antje. There are pre-sets in the material room, as well as materials for each zone.