Forum: Poser - OFFICIAL


 Subject: Helping Poser Newbies

basicwiz opened this issue on Apr 23, 2012 · 485 posts


  charlie43 ( posted at 12:37PM Wed, 16 May 2012 

@**paganeagle2001 - I have this procedure down pat, and know enough about the process to set constrained groups if needed. However, when I run a lot of simulations, I often get odd results. For example, I was working on a dynamic skirt for V4 and when I run the simulation, her arm was inside the skirt, even though I did not set the ignore constraint for hands for this sim. I also have a lot of problems with cloth bunching up in areas where the pose bends the figure. I'm running PP2010. Any suggestions? Below is an image of just one of the problems I run into.** **C~** **![cloth simulation](http://i453.photobucket.com/albums/qq251/zenbuddhist43/v4-hand.jpg)**