WIP WWII japanese pillbox

Work In Progress Military posted on Nov 25, 2020
Open full image in new tab Zoom on image
Close

Hover over top left image to zoom.
Click anywhere to exit.


Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.

Description


The pillbox had a trapezoidal face as 8.5ft high and 9ft across at base, with double-wall construction of 1/4 to 1/2in steel plate. The space between the plates was filled with sand. It had 2 levels, the upper one was for an observer or commander.

Comments (1)


angreif 11:34AM | Wed, 25 November 2020

I did not realize these were two levels. Are these available for 3d printing?

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.