3dcheapskate opened this issue on May 10, 2022 ยท 3 posts
3dcheapskate posted Tue, 10 May 2022 at 8:54 PM
Please feel free to post comments (good or bad*), suggestions for improvement, and/or questions about this freebie here.
Link to item in Renderosity Free Stuff: Freazypose (prototype 0.10) for Poser 9+
Link to item at ShareCG: Freazypose (prototype 0.10)
Link to item at DeviantArt: - - - N/A - - -
I intend to add more information here.
(My original Freazypose thread in this Renderosity Free Stuff forum which was created for Freazypose prototype 0.6 is here - Freazypose - a free PoserPython script to add EasyPose controls to a figure)
* if bad then constructive criticism is preferred :)
The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.
3dcheapskate posted Wed, 11 May 2022 at 12:16 PM
I've had a couple of people asking whether this works in Poser 12.
The answer is that I suspect not, although I think the changes required to get it to work may be minimal, and it may even be possible to create a version that works in both Python 2 (Poser 9-11) and Python 3 (Poser 12).
I've started a thread in the Renderosity PoserPython forum to look into what changes are required - Updating Freazypose 0.10 to work in Poser 12 | Renderosity
The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.
3dcheapskate posted Thu, 12 May 2022 at 4:54 AM
If anybody wants to help get this working in Poser 12 I've now taken it over to the Hivewire3D forum - post 21 on my Freazypose topic
The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.