3dcheapskate opened this issue on Sep 21, 2021 ยท 7 posts
3dcheapskate posted Tue, 21 September 2021 at 11:49 AM
The manual says that you can do it...
...but I can't see anything on the dialog to select it...
(this is a follow on from here, asking the same question but in a thread with an appropriate title)
The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.