I posted this over on the SM Poser forum, but apparently I have to wait 9500 seconds before I can respond to some of the replies over there, so thought I would try here as well.

I have a problem I have not encountered before. When trying to load a cr2, I get the message in the title, can't find file "com.obj". However, I have searched through the cr2, there is no reference to any file named "com.obj". I have checked every mc6 and every other document called by the cr2, nothing about com.obj. However, if I just press "Cancel" and then choose either yes or no for "continue looking for missing files?" the figure loads fine.

I thought maybe the problem was that my file paths were too long, so I shortened some of them, but the problem persists. Has anyone run into this or know what the problem is?

This is Poser 9, but I have a beta tester telling me the same thing happen in 10 and 11.

I use Notepad++ for editing. When searching the cr2 for "obj", it comes up with 2 hits:

RuntimeLibrariesCharacter3WC Morning CommuteUmbrella.cr2 (2 hits) Line 8: figureResFile :Runtime:Geometries:3WC-MC:Umbrella:Umbrella.obj Line 112: figureResFile :Runtime:Geometries:3WC-MC:Umbrella:Umbrella.obj So, they do not appear anywhere other than in figureResFile.

Thanks for any suggestions or solutions.

______________________________________________________________

Everything important in life I've learned from somebody else's forum signature.