allamosa opened this issue on Dec 02, 2013 · 7 posts
allamosa posted Mon, 02 December 2013 at 10:53 AM
I click the walk path and it is too long. How do I shorten it or is there anyway to customize it for exactly what I need. I click on the dots and it seems to shorten it but the figure still keeps going until the end.
Poser 9-Windows.
msg24_7 posted Mon, 02 December 2013 at 12:38 PM
Did you try using the scale parameters to adjust the length of the path?
I can't test right now, but I am pretty sure it works.
Yesterday's the past, tomorrow's the future, but today is a gift. That's why it's called the present.
allamosa posted Mon, 02 December 2013 at 1:14 PM
How do I find the scale parameters?
Tunesy posted Mon, 02 December 2013 at 1:59 PM
I'd suggest going to the top camera. Zoom as needed. Click and drag existing nodes as needed. Click on path (but not an existing node) to add new nodes. Alt-click to delete nodes.
msg24_7 posted Mon, 02 December 2013 at 2:33 PM
Quote - How do I find the scale parameters?
Select the path from the object drop down.
Now you can adjust scale, x- and z-scale parameters.
Finally you can adjust the path by dragging the control points and by adding additional control points.
Yesterday's the past, tomorrow's the future, but today is a gift. That's why it's called the present.
Tunesy posted Mon, 02 December 2013 at 2:43 PM
You can certainly scale the path, and you'll probably also translate it and y-rot it. And after that you'll probably start dragging nodes around. In most cases I'd just skip the scale/trans/rot stuff and just start dragging nodes. You'll end up in the same place in the end with fewer steps.
allamosa posted Tue, 03 December 2013 at 9:19 AM
Thanks to all. Very helpful.