been trying to do some modeling in cararra that I kinda want to make a bunch of little mechanical pieces, problem is that it's REALLY hard to get them to all fit together with out some sorta precision modeling where I can make things all the same size and such.  is there something I'm missing?  really want to be able to input precise measurements ..?

---

Hexagon, Carrara, Sculptris, and recently Sketchup. 

You might try using these.

cheers,
dr geep
;=]

Remember ... "With Poser, all things are possible, and poseable!"

cheers,

dr geep ... :o]

edited 10/5/2019

^^ what geep said however if you need beyond this you might have to look at one of the free/open source CAD packages then export to Carrara.

not a complete list nor even the best just a quick list found off the net.
http://www.freebyte.com/cad/cad.htm

 noo.. that might just do it,  as long as it's close I can push and pull in the assby room... just don't want to over distort  !!  :)  tanks  ;)

---

Hexagon, Carrara, Sculptris, and recently Sketchup. 

 ummm wait,  not there!!!

---

Hexagon, Carrara, Sculptris, and recently Sketchup. 

You need to ... Select a vertex ... or an edge ... or a polygon ... and it'll "be there."

cheers,
dr geep
;=]

Remember ... "With Poser, all things are possible, and poseable!"

cheers,

dr geep ... :o]

edited 10/5/2019

 ya, just figured that out... was hoping it could to the whole object though  :(  I think I can make it work this way if I think about it

---

Hexagon, Carrara, Sculptris, and recently Sketchup. 

Meanwhile ... back in the "Assemble" room ... do the whole object ??? ... :blink:

Why not.

cheers,
dr geep
;=]

Remember ... "With Poser, all things are possible, and poseable!"

cheers,

dr geep ... :o]

edited 10/5/2019