jackhalsey opened this issue on May 07, 2008 · 6 posts
jackhalsey posted Wed, 07 May 2008 at 8:52 PM
Hello
I created a scene in carrara and exported some pngs from it. I now want to go back in and export some more pngs from a different angle.
I open the saved carrara file and change the angle. Then I go into storyboard and tweak the camera dolly but when I render it renders the original scene angle.
Please advise and thank you.
pauljs75 posted Wed, 07 May 2008 at 9:00 PM
Rendering on the same camera as the viewpoint?
Set at the same time on the timeline as the adjustment?
Dunno what else to ask... I'm sure there might be other things to check.
Your friendly neighborhood Wings3D nut.
Also feel free to browse my freebies at ShareCG.
There might be something worth downloading.
jackhalsey posted Wed, 07 May 2008 at 9:05 PM
Yes to both I use the same camera just dollied up and the same time as I wanted to use the cuts.
bwtr posted Wed, 07 May 2008 at 9:06 PM
If you are involved with a still image why were you involved in the Story Board Room?
Did you need any more than say the Dolly Manipulator in the Assembly Room?
bwtr
Sueposer posted Wed, 07 May 2008 at 9:39 PM
Remember to check where the production frame is before you render. The scene in the preview window is not necessarily what the camera is looking at.
jackhalsey posted Thu, 08 May 2008 at 1:01 AM
I was using sequenced pngs and checked the production frame so I dont get it.