Hello Fellow Carrarians,

I am planning on purchasing C6 when the boxed version becomes available BUT ...
... in the meantime, I use C5 (5.1) but have a couple of problems ...

#1 - Using the vertex modeler - sometimes when trying to return to the Assemble Room, all I see is a cryptic note "preparing data ..." and the program hangs forever (?)
Has anyone else seen this condition?  Is there any way out - other than aborting the program?

#2 - Again, in the vetex modeler - Trying to delete (tool or key) a single vertex or edge, a whole section of edges get deleted leaving only the vertices visible.  Using the "Undo" works ok but is it not possible to delete a single vertex or edge?

Thanks for any insight you may have in these situations.

cheers,
dr geep
;=]
 

Remember ... "With Poser, all things are possible, and poseable!"

cheers,

dr geep ... :o]

edited 10/5/2019