biggert opened this issue on Oct 29, 2003 ยท 4 posts
biggert posted Wed, 29 October 2003 at 2:28 PM
OK...heres another question i have.....i want to edit poser 5 human figures.....so all i do is import the OBJ file in carrara 's assemble room....after that i click on a body part and then enter the model room but all i see is a small window that says the name of the OBJ part i clicked on (e.g. head.doc) on the upper left hand side, and a note that says "No Parameters"....the part i clicked on is not visible..... my goal is to create a morph for my human figure....but what am i doing wrong? :( thanks again for reading and for any advice!! i appreciate it!! =)
todd71_63116 posted Wed, 29 October 2003 at 2:52 PM
im not sure if this is still true of not, but used to Posers scale was a lot smaller than RDS, so you either had to zoom in a lot or use Scaler to make it larger and smaller...that may be why youre not seeing it...
falconperigot posted Wed, 29 October 2003 at 3:45 PM
Attached Link: http://www.geocities.com/porsche_carrara/Morphtargets1.htm
Check out the link - it should help. Mark
biggert posted Wed, 29 October 2003 at 8:12 PM
thanks a lot guys, especially to falconperigot! that was a really detailed link you gave! and todd71 i did see a tiny figure in the workspace but didnt know what to do with it and it only showed up when did something...forgot what that was. anyway, thanks again guys....i appreciate it very much! =)