bjbrown opened this issue on Mar 09, 2023 ยท 14 posts
SamTherapy posted Fri, 10 March 2023 at 7:26 AM
Yikes. I don't use Blender but IMO, the first problem is the cylindrical parts are too low poly. I'd at least double them before doing anything else. After that, I'd run a row of polys either side where the faces join to help Poser stop smoothing it out too much. Yes it adds to the poly count but it shouldn't be a problem on a modern system.
Also, there's a stray vert on the handle, which may not cause you any problems but if it was me, I'd kill it.
Coppula eam se non posit acceptera jocularum.