Well that is good news - thanks.

To be suitable for a release I want to also be sure that it terminates tidily when the selected actor is unsuitable (after displaying the appropriate dialogues of course).

I think I need to complete my dialogues flowchart. Then I'll be able to specify a small number of test runs that will exercise (almost*) every part of the code.

It'll probably take me a couple of days to do the flowchart as I'm quite busy today and this weekend. So in the meantime if anybody else would like to test prototype 11b in Poser 12 please do so, and post your results - ideally over on the Hivewire3D thread, but here is fine too.

*almost because I have a couple of bits of code to catch situations which should never occur - one of which was (or would have been if it wasn't for the syntax error in the dialogue line) displayed when you did your second test run with V3

---

The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.