3dcheapskate opened this issue on May 10, 2022 ยท 27 posts
3dcheapskate posted Wed, 11 May 2022 at 12:51 PM
adp001 posted at 12:42 PM Wed, 11 May 2022 - #4438455
Try LF (chr(10) or "\n") as EOL.
I'd already tried that ( https://www.renderosity.com/forums/comments/4438453/permalink ) - I get the same double spacing as when I used [CR][LF]
(Note: My "Hurrah ! It worked !" was reference to my previous post, not because LF alone worked. Your suggestion snuck in between them)
adp001 posted at 12:42 PM Wed, 11 May 2022 - #4438455
This is standard for years on all systems. For Poser too.
But apparently not for the Renderosity forums, eh ? ;)
The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.