undefined posted at 10:36 PM Sat, 25 September 2021 - #2965775

(This is a rewording of this post, but as a separate, appropriately titled thread)

...So if you cut and paste it you'll have to do the reverse, Edit > Blank Operations > Space to Tab (Leading) for it to work as Python...

I've just realized that what I said there about tabs was a load of tosh ! :rolleyes:

---

The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.