Forum: Poser 11

Subject: Creating a new master parameter that works modulo 360 - can it be done ?

3dcheapskate opened this issue on Sep 13, 2021 ยท 20 posts

3dcheapskate posted Thu, 16 September 2021 at 1:12 AM

...but I'm having no luck trying to create a sawtooth wave this way either. When I try to edit keys Poser changes adjacent keys to values I don't want, and sometimes ignores the key or value that I type in.

Problem.jpg

Even if I succeed there'll be curves at the two angles in the sawtooth waveform, and the vertical part won't be vertical, so the modulo values I get when the input is around Nx360 (N being an integer, so 360, 720, 1080, etc) will be incorrect.

I'm fairly sure that I'm onto a loser trying to do this with valueOpKey

The 3Dcheapskate* occasionally posts sensible stuff. Usually by accident. And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU or something else.
*soon only to be available in two flavours -  DAZ and Renderosity