Forum: Poser 11

Subject: Creating a new master parameter that works modulo 360 - can it be done ?

3dcheapskate opened this issue on Sep 13, 2021 ยท 20 posts

3dcheapskate posted Mon, 13 September 2021 at 4:21 AM

Also I've just realized that, of course, there's nothing special about the x/y/zRotate dials - no modulo 360 stuff going on there.

It is, of course, the way that they're used in the 3D simulation code that does it.

So my question is actually really simple:

"How can I add two numbers modulo 360 using valueOp maths ?"

The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.