Danny_G opened this issue on Jan 28, 2015 · 4 posts
3dcheapskate posted Wed, 28 January 2015 at 8:37 PM
Nice theme, loads of scope with this one... :)
(Danny: the challenge page says "Postwork is partly allowed. See Forum for specifics, because postworking restrictions may vary per challenge." but the OP of this thread doesn't give any specifics - so the usual question, what postwork is allowed on this one?)
The 3Dcheapskate (also available in DAZ and HiveWire3D flavours) occasionally posts sensible stuff. Usually by accident.
And it usually uses Poser 11, with units set to inches. Except when it's using Poser 6 or PP2014, or when its units are set to PNU.