The VM lets you hide, but you can only get one group in at a time, or at least what it is told a group is. The menu you show - that should allow selection of all but one group - to delete - so that the group can be isolated for save as a morph target - but it wouldn't - select one group and the menu rolls up. But, since it will not save the head as *.car - it is no help. Unless I can set up raw stock with stuff like lashes hidden, and only have to do it once, it means that morphs will take much longer to do - no pre-prep. It saved the figure less the head as a *.car. I tested Dina's head which is about the same size as V3 - same result - will not save as *.car - DAZ had nothing to do with this one. My bet is on the file size being too large. The tools are there, but I miss the selector tool - though the marquee does seem to do both jobs. Compose will probably not be able to handle V3's head. Probably have to use Poser to isolate morphs. That would be easier anyway, since it allows you to select what you want to export. I see why so many insist on exporting morph stock from Poser. -- You would have to hack a cr2 to get at the groups. The Carrara obj without disable autoscaling checked is huge - those morphs would be The Attack of the 50 Foot Woman. The figure is shin deep in the floor with centering off, so using that will ruin a morph too. I also have C v2.1, but the OBJ file I saved claimed it was from C v1.0. So they have done nothing with VM but make it a less able version of MFM v5.5? It burned a day, but now I understand better. For morphing RDS 5.5 is better than its offspring. Unless I am missing something Carrara needs to: Provide a way to get multiple groups into VM at the same time. Keep usemtl lines and to be helpful, be able to use them as selectors in VM Be able to save large meshes as a *.car file.